Online Access Free Cisco.300-515.v2026-07-29.q81 Practice Test (Page 15)

300-515 Exam Question 66

Refer to the exhibit. A network engineer is implementing an OSPF configuration.
Based on the output, which statement is true?

A.IPv6 routing not enabled is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway

B.OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.

C.OSPFv3 does not run for IPv4 on FastEthemet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface Fastfc.thernet0/0

D.In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.

300-515 Exam Question 67

A network engineer is implementing Layer 3 MPLS VPNs on Cisco IOS/IOS XE PE routers.
Which PE-to- CE routing protocol requires a separate routing process to be created for each VRF?

A.OSPF

B.RIPv2

C.BGP

D.EIGRP

300-515 Exam Question 68

Which configuration must be performed when an engineer implements MP-BGP to exchange IPV6 routes?

A.BGP peering must be activated under the IPv6 address family.

B.The bgp default ipv4-unicast command must be implemented on each router participating in MP- BGP.

C.BGP must be deployed in a fully meshed architecture within the autonomous system.

D.The participating routers must be configured within the same autonomous system

300-515 Exam Question 69

Which two frames can be configured on an Ethernet flow point? (Choose two.)

A.of a specific VLAN

B.with no tags

C.with different type of service values

D.with different class of service values

E.with identical type of service value

300-515 Exam Question 70

Refer to the exhibit. An engineer is implementing an MVPN solution between the source and the receiver. Streamers are connected and are forwarding streams to the AG1 source. The setup box is now receiving the multicast stream. Which additional action must the engineer take so that receiver RA also receives the stream?

A.Set redistribute connected subnets under address-family ipv4 vrf IPTV on the receiver.

B.Activate the source under BGP address-family ipv4 MDT on router RA.

C.Activate the receiver under BGP address-family ipv4 MDT on router AG1.

D.Set redistribute connected subnets under address-family ipv4 vrf IPTV on the source.

Other Version: 1612Cisco.300-515.v2022-10-01.q87; 34Cisco.Actual4test.300-515.v2022-03-14.by.jay.65q.pdf; 1907Cisco.300-515.v2022-01-17.q65; 1636Cisco.300-515.v2021-08-23.q62; 85Cisco.Ipassleader.300-515.v2021-08-12.by.fitch.65q.pdf

Latest Upload: 159Cisco.300-515.v2026-07-29.q81; 134Cisco.350-101.v2026-07-29.q43; 184Microsoft.PL-900.v2026-07-29.q187; 154Fortinet.FCSS_NST_SE-7.6.v2026-07-29.q64; 124NetworkAppliance.NS0-194.v2026-07-29.q28; 194Microsoft.SC-300.v2026-07-29.q174; 153VMware.250-614.v2026-07-29.q63; 150Microsoft.AI-901.v2026-07-28.q38; 133Oracle.1Z0-1032-26.v2026-07-28.q31; 145Cisco.300-725.v2026-07-28.q64

300-515 Exam Question 66

300-515 Exam Question 67

300-515 Exam Question 68

300-515 Exam Question 69

300-515 Exam Question 70

Download PDF File