H12-831_V1.0 Exam Question 6
On the OSPF network shown in the figure, the cost values of links are marked, and OSPF IP FRR is enabled on R1. Which of the following statements is false?


H12-831_V1.0 Exam Question 7
On the OSPFv3 network shown in the figure, OSPFv3 is enabled on the interfaces connecting R1, R2, and R3. The router ID of each router is 10.0.X.X, where X is the number of the router. If you check detailed information about an LSA on R3, the command output shows that the LSA is generated by R2 and describes the IPv6 prefix address associated with the Router-LSA.


H12-831_V1.0 Exam Question 8
To support the processing and calculation of IPv6 routes, IS-IS adds a new NLPID to TLV 129. The NLPID is an 8-bit field that identifies network layer protocol packets. Which of the following is the NLPID of IPv6?
H12-831_V1.0 Exam Question 9
IS-IS LSP fragments are identified by the LSP Number field their LSP IDs. This field Is 4 bits long.
Therefore, an -is process can generate a minimum of 256 LSP fragments, which means only a limited amount of information can be carried. By adding additional system 1Ds, you can enable the 1515 process o generate more LSP fragments.
Therefore, an -is process can generate a minimum of 256 LSP fragments, which means only a limited amount of information can be carried. By adding additional system 1Ds, you can enable the 1515 process o generate more LSP fragments.
H12-831_V1.0 Exam Question 10
On an MPLS network, when a transit device receives an MPLS packet and is ready to swap labels, it finds that the label value after swapping is 0. In this case, which of the following operations will the device perform?
Options:
Options:
