H12-831_V1.0 Exam Question 26
MPLS can carry multiple network protocol services, including unicast IPv4 services, multicast IPv4 services, unicast IPv6 services, and multicast IPv6 services.
H12-831_V1.0 Exam Question 27
On the OSPF network shown in the figure, area 1 and area 2 are common areas . The IP address of Loopback0 on R5 is 10.0.5.5/32 , and OSPF is enabled on this interface . If the abr-summary 10.0.5.0
255.255.255.0 command is run in area 2 (where R1 resides) , which of the following routers have the route
10.0.5.0/24 in their routing tables?

255.255.255.0 command is run in area 2 (where R1 resides) , which of the following routers have the route
10.0.5.0/24 in their routing tables?

H12-831_V1.0 Exam Question 28
Both VLAN aggregation and MUX VLAN are deployed on the enterprise network shown in the figure.
* All switch interfaces connected to terminals are access interfaces.
* Given this, match PC1 to PC4 with the hosts or servers they can access on the network.
( Note: A host cannot be matched with itself. For example, PC1 cannot match PC1. Tokens can be reused.)

* All switch interfaces connected to terminals are access interfaces.
* Given this, match PC1 to PC4 with the hosts or servers they can access on the network.
( Note: A host cannot be matched with itself. For example, PC1 cannot match PC1. Tokens can be reused.)

H12-831_V1.0 Exam Question 29
If the display ospfv3 peer verbose command is run to check OSPFv3 neighbor information, the command output contains information such as the peer router ID, global unicast address of the peer interface, and neighbor status.
H12-831_V1.0 Exam Question 30
A network engineer provides a troubleshooting report after rectifying a fault. The actual network is simplified into the one shown in the figure, where R1 and R2 both have OSPF enabled and function as the gateways of PC1 and PC2, respectively .
Given this, which of the following statements are true?

Network Topology:
* R1:
* Interface GE0/0/0 : 10.0.12.1/24 (Connected to R2)
* Interface GE0/0/1 : 192.168.1.1/24 (Gateway for PC1)
R2:
* Interface GE0/0/0 : 10.0.12.2/24 (Connected to R1)
* Interface GE0/0/1 : 192.168.1.2/24 (Gateway for PC2)
Options:
Given this, which of the following statements are true?

Network Topology:
* R1:
* Interface GE0/0/0 : 10.0.12.1/24 (Connected to R2)
* Interface GE0/0/1 : 192.168.1.1/24 (Gateway for PC1)
R2:
* Interface GE0/0/0 : 10.0.12.2/24 (Connected to R1)
* Interface GE0/0/1 : 192.168.1.2/24 (Gateway for PC2)
Options:


