H12-831_V1.0 Exam Question 11
On the IS-IS IPv6 network shown in the figure, multi-topology is enabled on all routers .
* The IPv6 address of Loopback0 on R4 is 2000::4/128 .
* The command ipv6 summary 2000::/64 level-1-2 is configured in the IS-IS process of R4 .

Which of the following statements is false ?
* The IPv6 address of Loopback0 on R4 is 2000::4/128 .
* The command ipv6 summary 2000::/64 level-1-2 is configured in the IS-IS process of R4 .

Which of the following statements is false ?
H12-831_V1.0 Exam Question 12
On the network shown in the figure, PC1 and PC2 are connected to the same switch (SW1) and belong to the same VLAN .

Which of the following are possible causes of a communication failure between PC1 and PC2?
Options:

Which of the following are possible causes of a communication failure between PC1 and PC2?
Options:
H12-831_V1.0 Exam Question 13
On the network shown in the figure, OSPF is deployed on R1 and R2. IS-IS is deployed on R2 and R3. To enable R1 to obtain the route to 10.0.3.3/32, ISIS routes are imported into OSPF on R2. In this case, the next hop address to 10.0.3.3/32 in the routing table of R1 is_____.


H12-831_V1.0 Exam Question 14
On the OSPF network shown in the figure, R1 and R2 use OSPF to communicate with each other through Loopback0 . In addition:
* MPLS LDP is enabled on R1 and R2 .
* The LDP transport address is the IP address of Loopback0 .
* A network engineer finds that an LDP session cannot be established between R1 and R2 and runs diagnostic commands (shown in the figure) to locate the fault.
Given this, which of the following are possible causes of the fault?

Options:
* MPLS LDP is enabled on R1 and R2 .
* The LDP transport address is the IP address of Loopback0 .
* A network engineer finds that an LDP session cannot be established between R1 and R2 and runs diagnostic commands (shown in the figure) to locate the fault.
Given this, which of the following are possible causes of the fault?

Options:
H12-831_V1.0 Exam Question 15
On the OSPFv3 network shown in the figure, OSPFv3 is enabled on the interfaces connecting R1, R2, and R3 . The router ID of each router is 10.0.X.X , where X is the number of the router .
If you check detailed information about an LSA on R3 , the command output shows that R1 and R2 are DRs on the network .
Options:
If you check detailed information about an LSA on R3 , the command output shows that R1 and R2 are DRs on the network .
Options:
