NCS-Core Exam Question 116
To prepare for a new Nutanix installation, a consultant downloads the Foundation VM, imports the VM to their Desktop Virtualization Solution, and powers on the VM. The IPv4 static address on the host workstation and the Foundation VM have been configured, but pings between them fail.
Which two troubleshooting steps should the consultant perform? (Choose two.)
Which two troubleshooting steps should the consultant perform? (Choose two.)
NCS-Core Exam Question 117
An administrator is configuring an All Flash cluster to support the following workloads:
* Full clone virtual desktops
* Hadoop
* Write heavy databases
Which three correct configuration options should the administrator use to meet the item requirements?
(Choose three.)
For each procedure, indicate whether it is a correct or incorrect procedure that must be configured to meet the item requirements using the drop-down option.
* Full clone virtual desktops
* Hadoop
* Write heavy databases
Which three correct configuration options should the administrator use to meet the item requirements?
(Choose three.)
For each procedure, indicate whether it is a correct or incorrect procedure that must be configured to meet the item requirements using the drop-down option.
NCS-Core Exam Question 118
Refer to the exhibits.
An administrator has reported that a new VM is not performing well.
After analyzing the information presented in the exhibits, which option shows the best conclusion regarding this workload?
An administrator has reported that a new VM is not performing well.
After analyzing the information presented in the exhibits, which option shows the best conclusion regarding this workload?
NCS-Core Exam Question 119
A consultant configures an ESXi cluster which will utilize a vSphere Distributed Switch (vDS). The consultant has just migrated the first host to the dvSwitch when several alerts appear within Prism Element regarding Host-to-CVM connectivity.
What is causing these alerts?
What is causing these alerts?
NCS-Core Exam Question 120
Refer to the exhibit.
A system administrator is using Range-Autofill tool to assign IP addresses to setup a multi-block cluster based on the following configuration:
Which additional changes must be made during the Foundation process to configure the cluster correctly?
A system administrator is using Range-Autofill tool to assign IP addresses to setup a multi-block cluster based on the following configuration:
Which additional changes must be made during the Foundation process to configure the cluster correctly?